Well Pump Keeps Running? No Pressure – but it’s Probably Your Well Pressure Tank

“It seems like our well pump is operating nonstop.”

If this sounds like your water system, there’s a technical term for it: “short cycling.” No sooner does the pump stop operating, than it starts up all over. It’s desperately working to sustain pressure within the system.

Why? The well pressure tank, which stores water drawn from the well prior to use, has a problem. The exact issue depends on the type of water pressure tank.

Most likely it’s “waterlogging,” which occurs in a bladder tank. These well pressure tanks, the most common type, hold water in a bladder inside their metal shells. Surrounding air pushes on the balloon, keeping the water under pressure.

All is well until the bladder springs a leak … and the air pocket fills with water. Bye-bye, water pressure.

Homeowners in Leipsig, it’s time to replace the tank … which means a call to Kelly James Service, the well water pressure tank specialists in Leipsig. They’ll put in a new pressure tank the same day, and stop your well pump’s endless short-cycling.

Air spitting from faucets? It’s another indication of a broken bladder. If the problem isn’t already serious, it soon will be.

Not all Leipsig residences with well water systems have bladder tanks. Some use an air volume control tank, a component of the well’s vertical in-ground pipe. The system uses bleeders, which allow a measured volume of water into the pipe. The water creates an air pocket, which generates pressure when the pump cycles to push in additional water.

Problems begin when these bleeders become blocked over time, lowering the starting water level in the pipe. With less water, pressure in the system falls. The pump cycles in a nonstop effort to provide additional water to maintain adequate pressure, and keep the system going.

A third type of well water pressure tank is made of galvanized metal, which requires. Usually used in older homes, these tanks eventually leak. Like an air volume control tank, the well pump operates near-constantly to maintain pressure as the internal water level drops.

Galvanized and air volume control tanks can also suffer from mineral accumulations. These constrain water flow from the tank into the home. Low water pressure results. Again, replacement is the only practical option.

Leipsig residents: Tired of hearing your well pump run endlessly? Let Kelly James Service bring back the peace – not to mention water pressure – that you expect. You’ll be amazed how short a time it takes them to stop your pump’s short-cycling.