We’re used to having water readily available. Just start the faucet, or shower, or hose, and it comes forth. The mechanical magic barely evokes thought. The water’s just unfailingly there.
So when something disrupts this reliability, the shock is undeniable and immediate. Decreased water pressure in the house? Worse yet, suddenly no water in the house? Yikes. Time to panic.
Maybe yes … or no.
If you have no water pressure in your Beaver Edge house – kaput, out, dry, nothing coming out of any faucet or spigot – very likely you require a new well pump. This pump, sometimes called a water pump, pushes water from the ground into your water system’s pressure tank. It waits for use in a sink, shower or toilet.
Well pumps on average work for 15 to 20 years. Their lifespan can be shorter or longer, based on the water being circulated and how they’re used. Their well-being often ties in with condition of the pressure tank, as well – replacement of both at the same time is not uncommon.
What is the cause of no water pressure in the house? The first step is to call Kelly James Service, the well pump and water solutions provider in Beaver Edge. Their knowledgeable professionals will troubleshoot your situation, and have your water running again within hours.
A well pump isn’t always the source of no water in the house. Occasionally an underground electrical wire breaks – a very repairable issue. Diagnosing power connections is always the first step undertaken by Kelly James Service.
If the problem is a well pump, though … then why? These pumps stop operating for different reasons. Age is unavoidable. Water with high iron content will significantly shorten pump life.
So will running water for hours on end, such as filling a pool or watering grass. These activities can lower the underground water table which, if it plummets too far, can cause the water-cooled pump to overheat.
Reduced water pressure in a Beaver Edge house is a different situation, albeit usually less serious. This condition shows up in toilets filling slowly, or weak water flows from faucets or showers. Sometimes water spits out irregularly, indicating air in the line.
The problem might be a clogged iron filter – again, for Beaver Edge homes with high iron content in water.
Otherwise, the problem usually ties to the pressure tank. Minimal or fluctuating water pressure means the well pump is short-cycling. The tank can’t sustain adequate pressure, forcing the pump to consistently turn on and off. Obviously, this takes a toll on the pump’s health.
Frankly, reduced water pressure in a home is a headache. It’s a problem that doesn’t just disappear, either. Ignoring the situation only makes it worse, as costly equipment can be damaged or stop working altogether.
The proactive measure – whether you have minimal water pressure in a house, or none at all – is to reach out to Kelly James Service. With more than three decades’ experience of providing water solutions, their professionals will get your water pouring again. It will be once again at your fingertips – exactly as you expect it to be. We are your proud Beaver Edge well pump service professionals!