Low Water Pressure in your Atwater Home?

No Water? Might Require a New Well Pump … Or Something Else

We’re acclimated to having water always available. Just start the faucet, or shower, or hose, and it pours out. The mechanical part barely registers. The water’s just unfailingly there.

So when something interrupts this stability, the shock is serious and instantaneous. Minimal water pressure in the home? Worse yet, suddenly no water in the home? Yikes. Time to panic.

Maybe yes … or no.

If you have no water pressure in your Atwater house – kaput, out, dry, nothing coming out of any faucet or spigot – very likely you need a new well pump. This pump, sometimes called a water pump, drives water from the ground into your water system’s pressure tank. It awaits use in a sink, shower or toilet.

Well pumps usually work for 15 to 20 years. Their lifespan can be shorter or longer, based on the water being pumped and how they’re used. Their well-being often ties in with condition of the pressure tank, as well – replacement of both at the same time is not uncommon.

What is the reason for no water pressure in the house? The first step is to call Kelly James Service, the well pump and water solutions provider in Atwater. Their knowledgeable team will analyze your scenario, and have your water restored within hours.

A well pump isn’t always the reason behind no water in the house. Occasionally an underground electrical wire breaks – a very repairable issue. Diagnosing power connections is always the initial step taken by Kelly James Service.

If the problem is a well pump, though … then why? These pumps wear out for various reasons. Age is unavoidable. Water with high iron content will significantly shorten pump life.

So will running water for hours at a time, such as filling a pool or watering grass. These pursuits can lower the underground water table which, if it drops too far, can cause the water-cooled pump to overheat.

Minimal water pressure in a Atwater house is a different scenario, albeit usually less serious. This condition manifests itself in toilets filling slowly, or weak water output from faucets or showers. Sometimes water spits out irregularly, indicating air in the line.

The problem might be a plugged iron filter – again, for Atwater homes with high iron content in water.

Otherwise, the problem usually connects to the pressure tank. Low or fluctuating water pressure means the well pump is short-cycling. The tank can’t maintain adequate pressure, forcing the pump to constantly turn on and off. Obviously, this takes a toll on the pump’s well-being.

Frankly, minimal water pressure in a home is a headache. It’s a problem that doesn’t just solve itself, either. Ignoring the issue only makes it worse, as costly equipment can be harmed or stop working altogether.

The proactive measure – whether you have reduced water pressure in a house, or none at all – is to contact Kelly James Service. With more than three decades’ experience of providing water solutions, their team will get your water pouring again. It will be right back at your fingertips – exactly as you expect it to be.  We are your proud Atwater well pump service professionals!